cecotec CONGA 4000 Carpet&Spot Clean XL Advance Manuel D'instructions page 53

- Switch off the appliance before unplugging it.
- After using the device, hang and wind the power cord in the power cord hook.
Cleaning embedded dirt
Warning:
- You can add low-foam detergent in the clean-water tank or apply it directly on the stain.
- Make sure the detergent will not damage the soiled surface before using it.
- Do not use thinners, aniline, chloroform, or flammable detergents.
Recommended liquids
- Alkaline ionised water.
- Low-foam detergent to the clean water tank combined with water in a 5:10 proportion.
- Citric acid
- Water with hydrochloric acid.
Non-recommended liquids
- Neutral kitchen detergent.
- Alkaline detergent.
- Acid detergent.
1. Apply detergent over the soiled surface, spray clean water, and scrub the dirt with a brush
to bring it to the surface.
2. Vacuum the dirt and do not let any detergent remain.
Warning:
- To know the detergent quantity and use, carefully read the manufacturer instructions.
- Stop using the appliance when the water or foam in the waste-water tank reaches the
maximum water level and clean the waste-water tank. Otherwise, water may enter the
appliance.
Using the right-angle suction nozzle
Press the suction nozzle against the soiled surface and move it from top to bottom.
5. CLEANING AND MAINTENANCE
Note
- Stop the appliance and unplug it from the mains before cleaning it.
- Do not wet the appliance to avoid the risk of electric shock.
- Do not use detergents, thinners, benzene, or other chemical agents to clean the appliance.
- After every use, you must remove and clean the waste-water tank, the clean-water tank,
and the suction nozzle to prevent humidity and dirt remains from emitting bad odours.
CONGA 4000 CARPET&SPOT CLEAN XL ADVANCE
ENGLISH
53