cecotec CONGA 4000 Carpet&Spot Clean XL Advance Manuel D'instructions page 52

ENGLISH
- 2 in 1 narrow nozzle
- XXL bristle nozzle
- Clean-water tank
- Waste-water tank
- Hose hook
- Accessory for windows
- Instruction manual
3. ASSEMBLY
1. Insert the suction nozzle in the appliance.
2. Remove the clean-water tank from the main body of the appliance by pressing the release
tab on the clean-water tank and pulling out the tank. Fill the tank with clean water up to
the "MAX" mark and install the clean-water tank back into the main body of the appliance.
Fig. 2
Note
- You can add low-foam detergent to the clean-water tank, combined with water in a 5:10
proportion.
- After using the appliance, you must empty the remaining water in the clean-water tank to
avoid leakage and mould formation.
- Do not shake the clean-water tank during installation, as it could cause water leakage.
4. OPERATION
1. Connect the product to the mains socket.
2. Press the power button to switch on the appliance.
3. Press and hold the water release button to spray clean water. Spray clean water on the dirt
to bring it to the surface.
4. Press the suction inlet on the dirt to bring water and dirt to the surface and vacuum them.
Fig. 3
5. Stop spraying clean water and vacuum the wastewater.
6. Switch off the appliance by pressing the power button.
7. Unplug it from the power supply.
8. Empty the clean and wastewater from the tanks and clean the waste-water tank.
Note
- It is normal for the surface to be wet after spraying.
- Do not spray water continuously over the same spot.
52