SNOWJOE sunjoe GTS4002C Manuel D'utilisation page 25

• Always store your grass trimmer + edger in a dry place.
Do not allow any liquid to get inside it.
• Keep the motor ventilation slots clean.
• If you see some sparks flashing in the ventilation slots, this
is normal and will not damage your power tool.
IMPORTANT! To ensure product safety and reliability, repairs,
maintenance, and adjustments to this power tool should be
performed only with identical replacement parts. Contact your
authorized Snow Joe + Sun Joe
®
+ Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.
Replacing the Spool + Clearing Jams
and Tangled Lines
m
WARNING!
Remove the battery from the unit before
changing the trimmer line.
1. Press together both release tabs on the line spool cover
and remove the cover by pulling it straight off (Fig. 53).
Fig. 53
2. Lift and remove the spool out of the hub (Fig. 54) and
clean out any dirt or grass residue.
Fig. 54
3. In case of jams or tangled line, unwrap about 6 inches
(15 cm) of line to ensure that it's not damaged.
dealer or call the Snow Joe
®
Spool cover
Tab
Spool
4. If it appears undamaged, rewind it and hook the line
end through one set of the slots of the spool. This will
temporarily prevent the spool from unwinding.
5. Unhook the line from the slot and carefully reinsert
through its respective slot on the side of the hub and
gently press the spool down (Fig. 55).
Fig. 55
®
Slot
6. Reinstall the spool cover by depressing the release tabs
into their slots in the hub, and push down until the spool
cover clicks into place (Fig. 56).
Fig. 56
Winding the Line
NOTE: A factory wound spool (model GTS4002C-RS-6PK)
is available for easy spool replacement on the GTS4002C
cordless grass trimmer + edger. Visit sunjoe.com to purchase
this accessory online. Should you wish to wind the line
yourself, the instructions are provided below. Self-winding,
however, is NOT recommended because if the line is not
wound properly it can cause the trimmer's auto feed system
to malfunction. For this reason, users are strongly urged to
purchase the pre-wound spool.
1. Stop the grass trimmer + edger, and remove the battery.
25
Spool
Spool cover
Tab