SNOWJOE sunjoe GTS4002C Manuel D'utilisation page 20

Grass Trimmer + Edger
Assembly
m
WARNING!
Do not insert battery until assembly is
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
Fitting the Safety Guard
m
WARNING!
The guard must be properly installed.
The guard provides the operator and other bystanders with
some protection from thrown objects.
1. Align the safety guard with the grass trimmer + edger
head as shown (Fig. 32).
Fig. 32
Grass trimmer
+ edger head
2. Firmly press the safety guard into place until it clicks into
the position (Fig. 33).
Fig. 33
Grass trimmer
+ edger head
Safety Guard
Safety Guard
Connecting to the Telescoping Pole
1. Open the assembly lock on the telescoping pole, and
push the grass trimmer + edger head into the opening on
the end of the pole (Fig. 34).
Fig. 34
Telescoping pole
2. When the lock tabs snap in, lock back the assembly lock,
and the grass trimmer + edger will be ready to use
(Fig. 35).
Fig. 35
Lock tab
3. To remove the grass trimmer + edger head, release
the On/Off switch and remove the battery. Unlock the
assembly lock, push the lock tabs on both sides, and pull
the grass trimmer + edger head out (Fig. 35).
20
Grass trimmer
+ edger head
Assembly lock
Assembly lock