SNOWJOE sunjoe GTS4002C Manuel D'utilisation page 21

Operation
Starting and Stopping
1. Slide the battery into the battery compartment until it
clicks to lock into position (Fig. 36).
Fig. 36
2. To turn the grass trimmer + hedger ON, push and hold
the safety lock switch (located on the handle) forward
with your thumb and then squeeze the On/Off switch with
your fingers. Once the tool is running, you can release the
safety lock switch (Fig. 37).
Fig. 37
3. To turn the tool OFF, release the On/Off switch (Fig. 37).
Adjusting the Telescoping Pole
This machine is equipped with a telescoping pole which can
telescope from 3.7 ft (1.1 m) to 5.3 ft (1.6 m). To adjust the
telescoping pole, follow the instructions below.
1. Disconnect the grass trimmer + edger from the power
supply by removing the battery from the compartment.
2. Unclip the telescoping lock to release the pole. Extend the
pole to the desired length (Fig. 38).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the grass.
Fig. 38
Pull
Telescoping lock
Battery
Safety lock
switch
On/Off switch
Pull
3. Lock the pole in position by closing the telescoping lock
(Fig. 39), and ensure that the pole is secured.
Fig. 39
m
WARNING!
Failure to lock the telescoping lock as
directed could result in personal injury.
Adjusting the Auxiliary Handle
The grass trimmer + edger is equipped with an auxiliary handle
that can be adjusted and removed. Follow the instruction
below to operate the auxiliary handle.
m
WARNING!
Make sure the knob, bolt, and the screws
are fixed into place after adjusting. Failure to lock any of them
as directed could result in personal injury or property damage.
To Remove the Auxiliary Handle
1. Disconnect the grass trimmer + edger from the power
supply by removing the battery from the compartment.
2. Screw the auxiliary handle lock knob and remove it with
the bolt, then the auxiliary handle can be pulled out
(Fig. 40).
Fig. 40
Bolt
3. Re-assemble the auxiliary handle lock knob and the bolt
on (Fig. 41).
Fig. 41
21
Telescoping lock
Auxiliary handle
Auxiliary handle
lock knob