Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Item:
FL-30PCS-KNTR
FL-60PCS-KNTR
FL-100PCS-SFYK
FL-100PCS-SFYK-HV
FL-200PCS-SFYK
FL-200PCS-SFYK-HV
FL-290PCS-SFYK
FL-290PCS-SFYK-HV
LED AREA LIGHT POWER & CCT SELECTABLE
FLOOD LIGHT POWER & COLOR SELECTABLE
INSTALLATION INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS!
MIN 75°C SUPPLY CONDUCTORS.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
To reduce the risk of fire, electric shock, personal injury, or property damage, please read
and follow all safety instructions. If you do not understand these instructions or if any
additional information is required, contact your local Topaz representative. Retain these
instructions for maintenance reference.
Do not exceed the allowed supply voltage marked on the luminaire label information.
Disconnect power at the circuit breaker panel before any installation.
Do not expose wire to any sharp objects such as sheet metal to prevent wiring damage or
abrasion.
While the light is on, please avoid direct eye exposure.
Combustible material should be kept away from fixture/LENS.
Do not make or alter any open holes in any enclosure or any electrical component during
installation.
Do not use when the enclosure is damaged or broken in any way.
Do not alter, relocate or remove wiring, lamp holder power supply or any other electrical
component.
Pursuant to NEC 410.69, "Effective January 1, 2022, where control conductors are spliced,
terminated, or connected in the same luminaire or enclosure as the branch-circuit
conductors, the field-connected control conductor shall not be of a color reserved for the
grounded branch circuit conductor or the equipment grounding conductor." And NEC
200.6(A)(2), "An insulated grounded conductor of 6 AWG or smaller shall be identified by
one of the following means: (2) The insulated conductor shall have a continuous gray outer
finish." For this reason, Topaz® will be transitioning from using Purple and Gray dimming
wires, to Purple and Pink dimming wires.
©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
INSTALLATION INSTRUCTIONS
WARNING
CAUTION
800-666-2852 | TOPAZ-USA.COM
Publicité
Manuels Connexes pour Topaz FL-30PCS-KNTR
Sommaire des Matières pour Topaz FL-30PCS-KNTR
- Page 1 200.6(A)(2), “An insulated grounded conductor of 6 AWG or smaller shall be identified by one of the following means: (2) The insulated conductor shall have a continuous gray outer finish.” For this reason, Topaz® will be transitioning from using Purple and Gray dimming wires, to Purple and Pink dimming wires.
- Page 2 See Figure 12. H M L 3. Install and tighten the ¾” plug once the selection has been made. Figure 11 Figure 12 800-666-2852 | TOPAZ-USA.COM ©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
- Page 3 3. Feed wires into the junction box. Connect wires according 10mm to the Wiring Diagram and close the junction box. See Figure 18. Figure 18 Figure 17 800-666-2852 | TOPAZ-USA.COM ©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
- Page 4 **REMARQUE : CES INSTRUCTIONS NE TRAITENT PAS DE TOUTES LES PERMUTATIONS QUI PEUVENT EXISTER DANS L’INSTALLATION, LA MAINTENANCE ET L’ENVIRONNEMENT D’EXPLOITATION. **NOTA: ESTAS INSTRUCCIONES NO ABORDAN TODAS LAS PERMUTACIONES QUE PUEDEN EXISTIR EN EL ENTORNO DE INSTALACIÓN, MANTENIMIENTO Y OPERACIÓN. 800-666-2852 | TOPAZ-USA.COM ©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
- Page 5 être identifié par l’un des moyens suivants: (2) Le conducteur isolé doit avoir une finition extérieure grise continue. » Pour cette raison, Topaz® passera de l’utilisation de fils de gradation violets et gris aux fils de gradation violets et roses.
- Page 6 Reportez-vous à la Figure 12. 3. Une fois la sélection effectuée, remettez en place et serrez le bouchon de 1,9 cm (¾ po). Figure 11 Figure 12 800-666-2852 | TOPAZ-USA.COM ©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
- Page 7 10mm Mont sur de jonction. Reportez-vous à la Figure 18. Tourillon Figure 18 Figure 17 800-666-2852 | TOPAZ-USA.COM ©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
- Page 8 Dans ce cas, terminez les fils Dim+ et Dim- séparément avec un capuchon. Noir: ACL Violet:Dim+ Vert: Rose:Dim- Blanc: ACN 800-666-2852 | TOPAZ-USA.COM ©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
- Page 9 6 AWG o menor se identificará por uno de los siguientes medios: (2) El conductor aislado tendrá un acabado exterior gris continuo". Por esta razón, Topaz® pasará de usar cables de atenuación púrpura y gris a cables de atenuación púrpura y rosa.
- Page 10 Ver la Figura 12. 3. Una vez hecha la selección, instala y aprieta el tapón de ¾”. Figura 11 Figura 12 800-666-2852 | TOPAZ-USA.COM ©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
- Page 11 10mm con muñón cables según el diagrama de cableado y cierra la caja de conexiones. Ver la Figura 18. Figura 17 Figura 18 800-666-2852 | TOPAZ-USA.COM ©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
- Page 12 Termina y cubre los cables Dim+ y Dim- de manera individual. Negro: ACL Morado:Dim+ Verde: Rosa:Dim- Blanco: ACN 800-666-2852 | TOPAZ-USA.COM ©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.