Topaz FL-30PCS-KNTR Instructions D'installation page 2

Item:
FL-30PCS-KNTR
FL-60PCS-KNTR
FL-100PCS-SFYK FL-100PCS-SFYK-HV
FL-200PCS-SFYK FL-200PCS-SFYK-HV
FL-290PCS-SFYK FL-290PCS-SFYK-HV
FLOOD LIGHT POWER & COLOR SELECTABLE
Bracket Installation Instructions:
1. Slipfitter Mount:
Figure 1
2. Knuckle Mount:
Figure 4
3. Trunnion Mount:
Figure 7
4. Yoke Mount:
Figure 9
CCT and Wattage Selection:
Figure 11
©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & ™Trademark of Southwire Company, LLC.
INSTALLATION INSTRUCTIONS
Figure 2
Figure 3
Figure 5
Figure 6
Figure8
Figure 10
5K 4K 3K
H M L
Figure 12
800-666-2852 | TOPAZ-USA.COM
1. Remove the mounting screws on the fixture and run the
wires through the fixture bracket. Reinstall the mounting
bolts. See Figure 1.
2. Route the fixture wires through the slipfitter mount. See
Figure 2.
3. Install the slipfitter mount onto the fixture using the
screws taken out in the previous step. See Figure 3.
1. Remove the mounting screws on the fixture and run the
wires through the fixture bracket. Reinstall the mounting
bolts. See Figure 4.
2. Route the fixture wires through the knuckle mount. See
Figure 5.
3. Install the knuckle mount onto the fixture using the
screws taken out in the previous step. See Figure 6.
1. Remove the bracket mounting screws on the fixture and
run the wires through the fixture bracket. See Figure 7.
2. Install the trunnion mount onto the fixture. See Figure 8.
1. Remove the bracket mounting screws on the fixture. See
Figure 9.
2. Install the yoke mount onto the fixture. See Figure 10.
1. Unscrew the ¾" plug. See Figure 11.
2. Set the switch to the desired CCT and Wattage to best suit
the application environment. See Figure 12.
3. Install and tighten the ¾" plug once the selection has been
made.