Publicité
Les langues disponibles
Les langues disponibles
9. Place "J" shaped tabs into the
slots on cord wraps
FIGURE 11. Press down until
tabs snap into place.
FIGURE 11
10. Press down on center of tool
holder until tab latches on bottom
of lid. FIGURE 12.
FIGURE 12
GENERAL SET UP
11. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
cleaning operation.
12. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
13. Insert machine hose end into inlet of tank. Twist
slightly to tighten the connection.
14. Attach the extension
wands to the accessory end
of the hose. Twist slightly
to tighten the connection.
FIGURE 13.
FIGURE 13
15. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 13.
16. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF.
NOTE: Many more useful tools are available at your
local dealer or Shop-Vac ® website.
Questions?
U.S. Customers call 888-822-4644
or visit www.shopvac.com 24 hours a day.
Canadian Customers call 905-335-9730
or visit www.shopvac.ca 24 hours a day.
PAGE 6
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
NOTE: Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause dust to discharge from blower
port and cause damage to motor.
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
NOTE: If foam sleeve (not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
17. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve (not standard with
all models) instead of the cartridge filter. When pick-
ing up fine dust or powders a high efficiency filter bag
(not standard with all models) must be used with
the cartridge filter.
NOTE: If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
18. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 14.
FIGURE 14
Publicité
