GE GTE21GTHBB Manuel D'utilisation Et D'installation page 17

REVERSING THE DOOR SWING
IMPORTANT NOTES
When reversing the door swing:
• Read the instructions all the way through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work surface for the doors.
IMPORTANT: Once you begin, do not move the cabinet
until door-swing reversal is completed.
These instructions are for changing the hinges from the
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
Unplug the refrigerator from its electrical outlet.
NOTE:
Do not let either door drop to the floor. To do
so could damage the door stop.
CAUTION
Lifting Hazard
The Fresh Food and Freezer doors are heavy Use
both hands to secure the doors before lifting.
TOOLS YOU WILL NEED
Phillips screwdriver
Masking tape
Allen wrench (Stainless Steel
Handle Models)
Installation Instructions
5/16 socket and ratchet
Putty knife or
thin-blade screwdriver
REMOVE FREEZER DOOR
1
1. Remove all food from the inner door liner.
2. Tape the door shut with masking tape.
3. Remove the hinge cover on top of the freezer door
with a thin-blade screwdriver.
4. Remove the three screws with a 5/16 socket and
ratchet, then lift the hinge straight up to free the
hinge pin from the socket in the top of the door.
Top Hinge
5. Remove the tape and tilt the door away from the
cabinet. Lift it off the center hinge pin.
6 Remove the hole covers with a putty knife on the
opposite side of the three hinges.
Hole Cover
7. Set the door on a non-scratching surface with the
inside up.
17
Bottom Hinge
Center Hinge
Hole Covers
Hole Covers