Rear Panel Features - Numark M1 Guide D'utilisation Rapide

REAR PANEL FEATURES

AC IN – Use the included power adapter
1.
to connect the mixer to a power outlet.
While the power is switched off, plug the
power supply into the mixer first, then plug
the power supply into a power outlet.
Note: The mixer is designed to work with
the included power supply only. Using an
incompatible power supply could result in
damage to the unit.
MASTER OUTPUT (RCA) – Use standard
2.
RCA cables to connect this output to a
speaker or amplifier system. The level of
this output is controlled by the MASTER
knob on the top panel.
LINE INPUTS (RCA) – Connect line-level devices, such as CD players, samplers or audio interfaces, to these
3.
inputs.
PHONO INPUTS (RCA) – Connect phono-level devices, such as turntables, to these inputs.
4.
GROUNDING TERMINAL – If you are using phono-level turntables with a grounding wire, connect the
5.
grounding wire to these terminals.
turntables are not grounded.
Note: Some turntables have a grounding wire built into the RCA connection and, therefore, nothing needs to be
connected to the grounding terminal.
TOP PANEL FEATURES
POWER LED – Illuminates when the mixer is
1.
on.
2. MASTER – This control adjusts the output
volume of the Program mix.
3. MIC GAIN – Adjusts the audio level of the
microphone signal.
4. CUE GAIN – Adjusts the level of the
headphone audio.
5. CUE SLIDER – Slide this to mix between
Channels 1 and 2 in the headphones. When
all the way to the left, only Channel 1 will be
heard. When all the way right, only Channel 2
will be heard.
CHANNEL GAIN – Adjusts the corresponding
6.
channel's pre-fader and pre-EQ gain level.
CHANNEL TREBLE – Adjusts the high
7.
(treble) frequencies of the audio on the
corresponding channel.
CHANNEL BASS – Adjusts the low (bass)
8.
frequencies of the audio on the corresponding
channel.
9. INPUT SELECTOR – Selects the input source
to be routed to the corresponding channel.
Input jacks are located on the rear panel.
10. CHANNEL FADER – Adjusts the audio level
on the corresponding channel.
11. CROSSFADER
between Channels 1 and 2. Sliding this to the
left plays channel 1 and sliding to the right
plays Channel 2.
Note: The crossfader is user-replaceable if it
should ever wear out. Simply remove the facepanel, then remove the screws holding it in position. Replace
the fader with a quality authorized replacement from your local Numark retailer only.
MIC INPUT – Connect ¼" microphones to this input. The microphone controls are located on the top
12.
panel.
HEADPHONES – Connect your ¼" headphones to this output for cueing and mix monitoring.
13.
If you experience a low "hum" or "buzz", this could mean that your
– Blends audio playing
1 2
6
7
8
9
10
12
5
5 5
GROUND GROUND
3 4 3 4
2
6
1
7
3
8
9
4
5
10
11
13