Publicité
Les langues disponibles
Les langues disponibles
Wiring connection
JVC Amplifier
10 A fuse
Remote
1
wire*
Ignition switch
Fuse block
Separate
red wire
Make this
connection if your
vehicle factory
wiring harness does
not have "12 V
ignition switch" wire.
Vehicle-specific Wiring Harness
(separately purchased)
*1
Not supplied for this unit.
If you have any troubles, try the following:
1
Check "Troubleshooting" (
2
Reset the unit. (
3
Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com
1
Signal cord*
Rear/subwoofer output
Antenna terminal
Join the same color wires
together.
Blue/white:
Remote (200 mA max.)
Orange/white: Illumination
Brown: Tel muting
Yellow: 12 V Battery
Red: 12 V Ignition switch
Black: Ground
White: Front speaker (left)
White/black
Gray: Front speaker (right)
Gray/black
Green: Rear speaker (left)
Green/black
Purple: Rear speaker (right)
Purple/black
page 17).
page 2)
Installation/Connection
Rear ground terminal
Factory wiring
harness (vehicle)
Recommended
connection
Blue: To power antenna
Blue/white: To amplifier
For more information:
Metra Electronics:
www.metraonline.com
Scosche Industries:
www.scosche.com
ENGLISH |
21
Publicité
