S+S Regeltechnik HYGRASREG AFTF-35 Notice D'instruction page 9

G HYGRASREG ® AFTF-35
TECHNICAL DATA
FUNCTION
ACCESSORIES
Type ⁄ WG01 Measuring Range
Humidity
AFTF-35 - I
A F T F - 3 5 - I / W 0...100 % RH
0...20 g/m
0...25 g/m
0...20 g/kg (MV)
0...25 g/kg (MV)
0...+50 °C
–20...+50 °C
–30...+30 °C
–20...+50 °C
A F T F - 3 5 - I / W LCD (as above)
AFTF-35 - U
A F T F - 3 5 - U / W (as above)
A F T F - 3 5 - U / W LCD (as above)
Note Alternative parameters are calculated internally from the measured variables,
which are retrievable via the active output OUT3:
absolute humidity, mixing ratio, dew point and wet bulb temperature
(can be changed via DIP switch)
ACCESSORIES
SF-M Metal sinter filter, Ø 16 mm, L = 32 mm, exchangeable
stainless steel V4A (1.4404)
WS-03 Weather and sun protection hood, 200 x 180 x 150 mm,
stainless steel V2A (1.4301)
A constant overtemperature of the humidity sensor makes its dewing considerably
more difficult or prevents its formation within the limits of the system.
A faster reaction speed is achieved in the case of humidity fluctuations, even in the
range above 95 % RH. The sensor (combined humidity and temperature measuring
element) is heated approx. 3 K above the ambient temperature. The actual relative
humidity is determined from the measured relative humidity at overtemperature,
the chip temperature of the sensor and the ambient temperature (via a second,
separate temperature measuring element).
see table
Temperature
0...+50 °C
3
(a.F.) –20...+50 °C
3
(a.F.) –20...+80 °C
0...+100 °C
(TP)
(TP)
(FKT)
(FKT)
(as above)
(as above)
(as above)
Output Output
active switching
3x 4...20 mA 1x Changeover
contact
3x 4...20 mA 1x Changeover
contact
3x 0 -10 V 1x Changeover
contact
3x 0 -10 V 1x Changeover
contact
9
Rev. Data - V20
Display Item No.
I variant
1201-714B-1000-000
1201-714B-1200-000
■
U variant
1201-714A-1000-000
1201-714A-1200-000
■
7000- 00 50- 2200- 100
7100- 00 40- 6000- 000
(continued)