Publicité
Les langues disponibles
Les langues disponibles
Bradley Combination Drench Shower/Eye Wash Unit
Model No. S19-310UU
Installation Instructions continued. . .
Step 2: Assemble drench shower and eye wash components
1. Assemble drench shower components first and then assemble eye wash components as shown on
pages 5–6.
2. When connecting steel chain, first connect the chain to the foot treadle "S" hook. Then with foot
treadle raised up, straighten the chain and
connect a link to the "S" hook on valve
handle.
• Make sure steel chain is pulled tight. The
length of chain used will vary.
• Apply pipe sealant (supplied by installer) to
all male-threaded pipe joints.
• Use grip pad around pipes when tightening
to prevent marring. Place the grip pad on the
pipe and then put the wrench over the grip
pad as shown in Figure 2. With grip pad in
place, turn the pipe with the wrench.
• The bottom edge of the showerhead should
be 7'-0" (2134mm) from floor.
Step 3: Connect water supply
IMPORTANT: Do not rely on Bradley's Combination Unit to support supply piping.
1. Connect the water supply piping to the 1-1/4" IPS inlet on the unit (piping supplied by installer).
Provide adequate supports (supplied by installer) for supply pipe using pipe hangers or other
means.
2. Connect drain piping to the 1-1/4" IPS drain outlet on the unit (piping supplied by installer).
3. Mount safety sign to wall or pipe using sign mounting hardware supplied.
4. Open the water supply lines. Test for leaks and adequate water flow.
4
Figure 2
Bradley Corporation • 215-163UU Rev. R; EN 01-501
Installation Instructions
Publicité
