Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Pre-Installation Information
IMPORTANT: This equipment should be inspected, tested and recorded weekly to maintain
IMPORTANT: This installation manual and parts list should be filed by the building owner's
Check Contents
Separate all parts from packaging and check each part with Figures 3 and 4 on pages 5–6, and the
Parts List on page 7. Make sure all parts are accounted for before discarding any packaging material.
If any parts are missing, do not attempt to install your Bradley Combination Unit until you obtain the
missing parts.
Supplies Required:
• (3) 3/8" floor anchors and bolts
• Pipe sealant
• Piping to 1-1/4" IPS water supply inlet on unit
• Adequate supply pipe supports
• Piping to 1-1/4" IPS drain outlet for eye wash on unit
• Minimum 4" drain to accommodate 30 gallons per minute discharge for drench shower waste
Installation Instructions
Step 1: Secure base and brackets to
floor
NOTE: Flush the water supply line before
making connections.
1. To secure base to floor, install three
suitable anchors (supplied by installer)
for 3/8" bolts in the floor (Figure 1).
2. Bolt the base to the floor anchors using
3/8" bolts (supplied by installer).
Installation Instructions continue...
Bradley Corporation • 215-163UU Rev. R; EN 01-501
proper operation. Main water supply to the unit should be "ON" at all times.
maintenance department.
Bradley Combination Drench Shower/Eye Wash Unit
Figure 1
Model No. S19-310UU
3
Publicité
