Electrolux 600 Serie Notice D'utilisation page 22

22 www.electrolux.com
Problem and alarm code
You cannot activate the
appliance.
The programme does not
start.
The appliance does not fill
with water.
The display shows
.
The appliance does not
drain the water.
The display shows
The anti-flood device is on.
The display shows
The appliance stops and
starts more times during
operation.
The programme lasts too
long.
The remaining time in the
display increases and
skips nearly to the end of
the programme duration.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
Possible cause and solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no damaged fuse in the fuse
box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for
the end of the countdown.
• The appliance recharges the resin inside the water
softener. The duration of the procedure is approxi‐
mately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your local
or
water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog‐
ged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clog‐
ged.
.
• Make sure that the interior filter system is not clog‐
ged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap and contact an Authorised Serv‐
ice Centre.
.
• It is normal. It provides optimal cleaning results and
energy savings.
• If the delay start option is set, cancel the delay set‐
ting or wait for the end of the countdown.
• Activating options can increase the programme dura‐
tion.
• This is not a defect. The appliance is working cor‐
rectly.
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• Parts of the tableware are protruding from the bas‐
kets.