Télécharger Imprimer la page

Simpson MS60763-S Guide D'utilisation Et D'entretien page 20

Masquer les pouces Voir aussi pour MS60763-S:

Publicité

Les langues disponibles

Les langues disponibles

The engine is shipped from the factory without oil. Running the engine without oil will
result in severe engine damage and void the warranty. To avoid causing engine damage
and voiding the warranty, fill the engine with the recommended oil type before starting.
Oil is a major factor in the performance and service life of any engine. Using the incorrect
oil may damage the engine and void the warranty. To avoid causing engine damage and
voiding the warranty, check and change oil as required using the correct engine oil.
1. Check oil with pressure washer on a level surface and the engine off.
2. Unscrew the engine oil dipstick and pull it out, then wipe dipstick clean.
3. Place clean dipstick into filler neck but do not thread it in, leave it rest it on the filler neck.
4. Remove the dipstick from filler neck and check oil level. Oil level should be at the upper oil
limit on the dipstick.
5. If level is low, add the recommended oil to the crankcase until the level reaches the upper
limit on the dipstick. See the engine manual for recommended oil.
6. Install the dipstick and tighten cap by threading it into the filler neck.
Engine oil drain
plug (not visible)
Page 17
NOTICE
NOTICE
Engine oil dipstick
FILL ENGINE OIL BEFORE USE
USE CORRECT ENGINE OIL
Upper Oil Limit
Lower Oil Limit

Publicité

loading