Before connecting a water supply hose, be sure the water supply is capable of providing an
uninterrupted source of clean, cold water at a minimum rate of 5 gallons per minute (GPM)
and 20 pounds per square inch (PSI) of pressure. Once a proper water supply is secured,
follow the instructions below to connect both the water supply and high-pressure hoses to
the pressure washer.
1.
Verify the inlet screen is free of
any dirt or debris and is in place
with the convex side facing out.
2.
Turn on the water supply and
run for 30 seconds to purge any
debris from the supply hose.
Then, turn off the water supply
and thread the water supply hose
into the pump inlet.
3.
Thread the high-pressure
hose connector onto the pump
high-pressure outlet.
4.
Thread the high-pressure
hose connector onto the
spray gun.
Page 10
CONNECTING HOSES