KitchenAid Sculptura KUDS24SE Guide D'utilisation Et D'entretien page 19

Canceling a cycle
You can cancel a cycle anytime during
the cycle.
+. Press the Cancel pad once, then wait.
The Cancel light will glow. There
is a 5 second pause between
CANCEL the time Cancel is pressed and
draining begins.
Option selections
Press a pad to select an option. If you
change your mind, press the pad again to
turn the option off. To select a different
option, press another pad.
High Temp. Wash
Select this option and water will heat during
ai * Water heating is automatic in
* | the wash portions and final rinse
WASH of the Soak and Scrub cycle, and
in the final rinse of the Normal, Short
Wash, and Light China cycles.
Energy Saver Dry
Use this option to air dry dishes without heat.
For best results, keep the rinse
agent dispenser filled. Under
certain conditions (hard water,
empty rinse agent dispenser,
plastic items in the load, etc.) you might find
some water left on plastics, dishes, and
silverware.
the main wash for better cleaning.
2. Let the dishwasher drain completely.
SANI-RINSE* Option
The SANI-RINSE option raises the water
temperature in the final rinse to
a 160°F (71°C). SANI-RINSE is an
option with all cycles except Rinse
Only. Depending on the incoming
temperature of your water, cycle times might
be longer when you select SANI-RINSE.
Delay Hours
The Delay Hours light glows when the dish-
washer has been set for a delayed
DELAY | start. The delay light will turn off
HOURS | when the cycle starts. See page 21
on "Setting a delay start".