Publicité
Les langues disponibles
Les langues disponibles
5. Fit the stainless steel lance into the trigger gun and rotate
the collar until the two parts are completely locked (Fig. 4).
Fig. 4
Trigger gun
Stainless
steel lance
6. Connect the high-pressure hose to the trigger gun
(Fig. 5).
Fig. 5
High-pressure hose
m
WARNING!
Keep hose away from sharp objects. Bursting
hoses may cause injury. Examine hoses regularly and replace if
damaged. Do not attempt to mend a damaged hose.
7. Connect the garden hose adapter (female coupler) to the
water inlet of the pressure washer, then thread your garden
hose (male end) into the garden hose adapter
(Fig. 6). The garden hose must have an internal
diameter of at least 13 mm (1/2 in.) and must be reinforced.
The water supply must be at least equal to
the washer delivery capacity.
NOTE: The machine is not suitable for connection to a
potable water main.
Collar
Trigger gun
m
exceed 104°F/40°C. The water supply must not exceed
0.7 MPa.
m
water; use of unfiltered water containing corrosive chemicals will
damage the washer.
9
Garden hose
This end to the
(male end)
water inlet on
the unit
Fig. 6
Garden hose
8. Attach garden hose to water supply (Fig. 7).
Fig. 7
Connect to water supply
Garden hose
WARNING!
The intake water temperature must not
CAUTION!
The washer must only be used with clean
9. Make sure the motor switch is pushed to the OFF (0)
position before plugging the unit into the power outlet
(Fig. 8).
Fig. 8
Water inlet
(female coupler)
Publicité
