Publicité
Les langues disponibles
Les langues disponibles
Safety, performance, and dependability have been given top
priority in the design of your panel light.
INTENDED USE
The panel light is intended for general illumination. Do not
use the product in wet conditions.
Do not use the product for any other purpose. Use of the
product for operations different from intended could result in
a hazardous situation.
PANEL LIGHT SAFETY WARNINGS
■
The light source contained in this luminaire shall only be
replaced by the manufacturer or his service agent or a
similar qualified person.
■
Use only with recommended battery pack and charger.
Any attempt to use another battery pack will cause
damage to the product and could possibly explode,
cause a fire, or personal injury.
■
Do not disassemble the product.
■
If wrapped or in contact with fabrics, the lens can
produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the lens to come in
contact with anything.
■
Do not place the product or battery pack near fire or
heat. This will reduce the risk of explosion and possible
injury.
■
Remove the battery pack or disconnect the mains power
before starting any work on the product.
■
Do not store the product in a damp or wet location, or in
a location where the temperature may reach or exceed
40°C. For example, inside sheds, vehicles, or metal
buildings in the summer.
■
This product contains a light source of energy efficiency
class "F".
BATTERY SAFETY WARNINGS
■
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your
tool, battery pack or charger in fluid or allow a fluid to
flow inside them. Corrosive or conductive fluids, such
as seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a short
circuit.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps or
tape. Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.
KNOW YOUR PRODUCT
See page 55.
1. On/off switch
2. AC port
3. Battery port
4. Carrying handle
5. Light panels
6. Wall mount holes
7. Mounting screw hole(1/4")
8. Operator's manual
9. Battery pack
10. Charger
MAINTENANCE
■
Use only original accessories and spare parts. Should
components need to be replaced which have not been
described, please contact an authorised service centre.
All repairs should be performed by an authorised service
centre.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
■
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
SYMBOLS
V
Volts
Direct current
Class II, double insulated
European Conformity Mark
British Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
Please read the instructions carefully
before starting the product.
Do not stare at the light source.
To reduce the risk of injury or damage,
avoid contact with any hot surface.
The control gear can be replaced by
a service agent or a similar qualifi ed
person.
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
3
Publicité
