Fulgor Milano F7WD30 Serie Instructions Pour L'installation Et L'utilisation page 18

EN
Installation procedure
Before you begin assembling the drawers of the appliance, make sure there is enough room to fit the drawer and the
appliance.
The precise dimensions for the installment are indicated in inches and mm.
Install an anti-tip block against the rear cabinet wall. Verify screws are adequately secured and do not penetrate electrical
wiring or plumbing.
• Turn power off to the electrical outlet.
• Insert plug into three-prong, grounded outlet (see "Power
Requirements and Grounding" on page 2 for electrical
specification).
• Position the drawer so that it is directly centered and slide
warming drawer assembly into cutout until it is flush with
cabinet.
• Avoid pinching the power cord between the unit and
cabinet wall.
• Open the warming drawer to full extension and fix the
structure to the wall with the four screws provided.
16
=
22 7/8"
=
(580)
INSTALLATION
• Turn power back on to the electrical outlet.
• Turn the warming drawer on. Close the drawer for
approximately 1 minute then check for warmth.