Publicité
Les langues disponibles
Les langues disponibles
Switch trigger and brake lever
CAUTION:
Before installing the battery car-
tridge into the machine, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the machine, pull the switch trigger. Using the
switch trigger, the speed can be adjusted within the set
speed range. To stop the machine, release the switch
trigger and pull the brake lever.
To lock the brake lever, pull and hold the brake lever,
then pull the lock lever, and then release the brake lever
while pulling the lock lever. To release the lock, pull the
brake lever.
1
Fig.24
► 1. Switch trigger
2
Fig.25
► 1. Brake lever 2. Lock lever
Tilt switch
CAUTION:
when you operate the tilt switch.
CAUTION:
sure that the remaining battery capacity is not
low. If the battery capacity is low, lock the brake
lever, and then switch the battery cartridges to
charged ones or replace the battery cartridges
with charged ones.
Fig.26
► 1. Tilt switch
You can tilt the bucket or carrier using the tilt switch. To tilt the
bucket or carrier forward, press the upper side of the tilt switch
while holding the brake lever. To return the bucket or carrier, press
the lower side of the tilt switch while holding the brake lever.
1
NOTE: The beep sound is emitted while the bucket or
carrier is moving.
Adjusting the width of the carrier
NOTICE:
Make sure that the side rails and front rail
are fixed securely after tightening the thumb nuts.
Loosen 6 thumb nuts, and then slide the side rails and front
rail. Tighten the thumb nuts to fix the side rails and front rail.
Fig.27
► 1. Thumb nut 2. Rail
19 ENGLISH
Be sure to hold the brake lever
Before using the tilt switch, make
1
1
2
Publicité
