Publicité
Les langues disponibles
Les langues disponibles
English
(3) First pull the Trigger.
Next, depress the Push Lever against the wood.
□ THE NAILER MUST NOT OPERATE.
(4) Without touching the Trigger, depress the Push Lever
against the wood.
Next, pull the Trigger.
□ THE NAILER MUST OPERATE.
ADJUSTING AIR PRESSURE
Adjust the air pressure at recommended operating
pressure 80 – 120 psi (5.4 – 8.3 bar 5.5 – 8.5 kgf/cm
according to the length of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.
LOADING NAILS
● When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Grip the nail guide and knob with fi nger.
Press the knob down and swing the nail guide open.
And open the magazine cover.
14
Pull Trigger
WARNING
● Do not exceed
120 psi (8.3 bar
8.5 kgf/cm
WARNING
Knob
(2) Adjust the position of the plate according to the nail
length.
The nail will not feed smoothly if the plate is not
correctly adjusted.
Magazine
).
2
NOTE: Before loading nails in the magazine, adjust
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
)
2
1 Slide in vertical direction possible.
Lift or lower the nail holder to accept diff erent
length nails.
2 Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 45
degrees.
Magazine
Magazine cover
Nail guide
Magazine cover
Nail holder
1
2
Nail holder
1
1
/
"
2
3
1
/
"
4
1
2 2
/
"
4
1
2
/
"
2
Publicité
