Ryobi PBLHM101 Manuel D'utilisation page 5

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper in-
terpretation of these symbols will allow you to operate the product better and safer.
SYMBOL
V Volts
min Minutes
Direct Current
n o
No Load Speed
.../min Per Minute
PRODUCT SPECIFICATIONS
No Load Speed ......................... 0–500/0–2,100/min (RPM)
Clutch.................................................................24 position
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
NAME
Voltage
Time
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute
FEATURES
ASSEMBLY
SYMBOLS
DESIGNATION/EXPLANATION
Torque .................................................................. 750 in.lb.
Hammer Speed
(Blows per minute) ..................... 0–5,400/0–31,000 BPM
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.
INSTALLING/ADJUSTING THE AUXILIARY
HANDLE ASSEMBLY
See Figure 1, page 10.
The auxiliary handle assembly can be installed on either
side of the tool.
To install the auxiliary handle assembly:
 Remove the battery pack.
 Turn the handle grip counterclockwise to loosen it and
open the hooks wide enough to fit over the mounting ribs,
behind the torque adjustment ring.
 Place the hooks over the mounting ribs, making sure the
hooks are positioned in the slots as shown.
 Turn the handle grip clockwise to tighten. Make sure the
handle assembly is secure before beginning operation.
5 — English