Télécharger Imprimer la page

Craftsman 580.676621 Manuel De L'opérateur page 11

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
4.
Engage trigger lock on spray gun when not in use.
WARNING: The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious injury
and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction and squeeze spray
gun trigger, to release high pressure, every time you stop
engine. Engage trigger lock when not in use.
How To Use the Adjustable Nozzle
You should now know how to START and STOP your
pressure washer. The information in this section will tell you
how to adjust the spray pattern and to apply pressure washer
specific detergents.
WARNING: The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious injury
and possible amputation.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
1.
Slide nozzle backward to achieve high pressure. Slide
nozzle forward when you wish to adjust spray to low
pressure mode.
2.
Point nozzle down towards a firm surface, disengage
trigger lock, and press trigger to test pattern.
3.
Twisting nozzle adjusts spray pattern from a fan pattern
to a narrow pattern.
Usage Tips
For most effective cleaning, keep spray nozzle from 8 to
24 inches away from cleaning surface.
If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
DO NOT get closer than 6 inches when cleaning tires.
Applying Detergent with Adjustable Nozzle
CAUTION: Chemicals can cause bodily injury, and/or
property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
To apply detergent, follow these steps:
1. Review use of adjustable nozzle.
2. Prepare detergent solution as required by job.
3. Place filter end of detergent siphoning tube into
detergent container.
NOTE: Make sure the filter is fully submerged in detergent
while applying detergent.
NOTICE: Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the siphon into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
4. Slide adjustable nozzle forward to low pressure mode.
NOTE: Detergent cannot be applied with nozzle in high
pressure position.
5. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE: You must attach all hoses before you start the
engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
11

Publicité

loading