Securing The Child - Diono monterey 5 iST FixSafe Manuel D'instructions

SECURING THE CHILD

1. Properly position child in installed seat. Child
should be sitting upright and seated all the way
back in the booster seat.
2. Adjust head support to proper height: The
guide should be slightly above the child's shoulders (at least 1 cm).
Squeeze the head support adjustment lever on the back of the
booster seat while adjusting it's height up or down to fit the child.
NA
2
3. Feed the shoulder portion of the vehicle seat
belt through the RED upper belt guide by
inserting the belt behind the metal clip.
4. Fasten vehicle seat belt across child. The lap
portion of the vehicle seat belt should rest
NA
within both lower belt guides. Make sure the
seat belt is not twisted and lays flat across
child's lap, torso and shoulder.
18
monterey 5
1
RED shoulder belt
3
4
5. Tighten the vehicle seat belt by pulling the
lap and shoulder belt portion in the
direction of the arrows.
6. Confirm seat belt buckle is in correct position –
it should align with the RED
on headrest and side of seat.
IMPORTANT: The Vehicle Shoulder Belt MUST route completely through
the RED shoulder belt guide and not fall off the child's shoulder.
IMPORTANT: When using the diagonal portion of the seat belt, it should
lay over the shoulder and should NOT be touching the child's neck.
PROPER BUCKLE POSITION
IMPORTANT: After booster seat is installed and seat belt is fastened
around child, it is important to confirm correct seat belt buckle
position to ensure secure installation.
NA
CORRECT BUCKLE POSITION
Buckle is on the outside of lower
belt guide.
SECURING THE CHILD
belt path guides
5
INCORRECT BUCKLE POSITION
If buckle is being pulled across
the lower belt guide and into
the seat, choose another seating
position within the vehicle.
diono.com
19