Philips L'OR Barista LM8014 Mode D'emploi page 19

English
22
Meaning of light signals
Troubleshooting
Problem
The machine does not switch
on.
The on/off button is flashing
slowly.
The brewing time is longer
than before.
The temperature of freshly
brewed coffee gradually
decreases.
The pump makes a lot of
noise.
12 When the flushing cycle has finished, the ristretto and lungo button flash
a few times.
Note: It is normal that some water remains behind in the water tank after
the descaling procedure.
The machine switches off. The descaling procedure is finished.
- The on/off button flashes slowly: the machine is heating up.
- The on/off button flashes quickly: the water tank is empty, fill the water
tank with tap water.
- All buttons light up continuously: the machine is ready for use.
- The selected coffee button flashes slowly: the machine is preparing the
coffee recipe.
- The selected coffee button flashes quickly:
-
Programming is activated.
-
The new coffee quantity is saved.
- The ristretto and lungo button flash simultaneously after brewing coffee:
you need to descale the machine.
This chapter summarizes the most common problems you could encounter
with your machine. If you are unable to solve the problem with the
information below, visit www.lorbarista.com/support for a list of frequently
asked questions or contact the Consumer Care Center in your country.
Troubleshooting coffee machine
Possible cause
The machine is not connected to
the mains.
The machine is heating up.
The machine is clogging up with
scale.
The machine is clogging up with
scale.
There is not enough water in the
water tank.
The water tank is not placed
correctly.
Solution
Put the plug in an earthed wall
socket.
This is normal.
Descale the machine.
Descale the machine.
Fill the water tank with fresh tap
water.
Place the water tank correctly
and push it downwards.