Publicité
Les langues disponibles
Les langues disponibles
Cleaning
The panel, terminals and connectors of the equipment must stay dry and clean. Cleaning should
be made using a wet cloth in water and a soft detergent or isopropyl alcohol (be sure that the
products to be used for cleaning does not affect plastic goods).
To avoid electrical shock, make sure that the equipment is completely dry before Power
it On.
Replacement fuse
z Perform the procedures below with the equipment turned off
z Disconnect the equipment from the mains supply and remove the power cord
z Disconnect the test leads
z To replace the fuse, use only the fuse type specified in the equipment
1.
With a screwdriver, remove the fuse holder cover, lightly pressing the lid and turning ¼ counter
clockwise.
2.
Remove the blown fuse and insert a new fuse in the fuse holder cover.
3.
Place the cover in the compartment and with the screwdriver turn ¼ clockwise or until the
fuse holder cover properly fits the fuse compartment.
Fuse Schurter, model SPT 5x20 (Time-lag) 5A/250V. High breaking capacity.
20
Publicité
