Publicité
Les langues disponibles
Les langues disponibles
„ Selecting the test type
„ Manual mode
In manual mode, the user selects and adjusts the current value during the test, using the
1.
Access the device's MENU pressing the
2.
Use the
to select TEST TYPE and press
3.
Use the
to select MANUAL and press
4.
Exit the menu and perform procedure described on page 14 of this manual to start the test.
„ Production line mode
In order to optimize sequential measurements on production lines, the MPK256 has a standard
function that keeps the configuration settings of the last test to be applied to the next
measurement.
1.
Access the device's MENU pressing the
2.
Use the
to select TEST TYPE and press
3.
Use the
to select PRODUCTION LINE and press
4.
Exit the menu and perform procedure described on page 14 of this manual to start the test.
To use this feature, follow the procedure described on page 14 of this manual, with one
difference: press the stop key (
shown in the display, replace the sample to be measured and press the start key (
equipment will gradually increase the applied current until it reaches the value from the previous
test.
The last test settings values will be erased if the stop button (
more times, the range of the test is changed or the equipment is switched off.
.
to confirm.
to confirm.
.
to confirm.
) only once. When the test is finished and the results are
15
to confirm.
) is pressed two or
MPK256
.
). The
Publicité
