Beurer FB 65 Mode D'emploi page 19

6. CLEANING AND MAINTENANCE
CAUTION
Make sure that no water gets inside the device! Make sure that the foot bath is switched o and
unplugged every time before cleaning.
1. After use, unplug the foot bath and empty the water via the narrow side.
2. To make it easier to empty the foot bath, we recommend carrying it with the straight side facing the body.
3. Then rinse the foot bath with clean water.
4. For hygienic cleaning, a mild, non-foaming/abrasive cleaning product can be used (e.g. neutral vinegar).
5. To dry out the air lines after cleaning, switch the bubble function on without water for approximately 1
minute. You can wipe any drops o with a cloth.
6. The storage bag for the pedicure attachments can also be used at the same time as a cloth to clean/dry
the foot bath.
7. To make cleaning/drying easier, you can remove the massage roller attachments
by removing them with a gentle lever action.
8. After cleaning, store the foot bath in its original packaging and in a dry place. Do not leave the foot bath
open for prolonged periods of time.
7. DISPOSAL
For environmental reasons, do not dispose of the device in household waste at the end of its service life.
Dispose of the device at a suitable local collection or recycling point in your country. Observe the local
regulations for material disposal. Dispose of the device in accordance with EC Directive Waste
Electrical and Electronic Equipment (WEEE). If you have any questions, please contact the local
authorities responsible for waste disposal. You can obtain the location of collection points for old
devices, for example, from the local or municipal authorities, local waste disposal companies or
your retailer.
8. TECHNICAL SPECIFICATIONS
Power supply: 220-240 V~, 50-60 Hz, 650 W
Size: 45.0 x 39.0 x 18.4 cm
Weight: Approx. 3.45 kg
9. WARRANTY
Further information on the warranty and warranty conditions can be found in the warranty leaflet sup-
plied.
19
from the foot bath
7