Publicité
Les langues disponibles
Les langues disponibles
Leak Check Method
1. Make 2-3 oz. of leak solution by mixing one part
liquid dishwashing soap with three parts water.
2. Make sure control knob is in the "OFF" position.
3. Spray or paint some leak solution on the
cylinder and regulator connection.
4. Inspect the solution at the connections, looking
for bubbles. If no bubbles appear, the
connection is secure.
5. If bubbles appear, a leak is detected. Go to step
6.
6. Disconnect the cylinder from the regulator, and
reconnect. Make sure the connection is secure
and no leak is found before using the grill.
7. If you continue to see bubbles, DO NOT USE THE GRILL. Repeat the above process with a
different LP cylinder. If leaks are still present, contact the customer service center.
5.5 Lighting instructions
1. Read all instructions before lighting.
2. Open lid during lighting.
3. Make sure the gas control knob is in "OFF" position.
4. Unfold side tables into the open position.
5. Push the gas control knob and quickly turn counterclockwise to
"HIGH" position. The igniter will click and light the burner.
6. If ignition does not occur in 5 seconds, turn the gas control knob
off, wait 5 minutes, and repeat steps 2 - 5.
* Before cooking on this grill for the first time, operate the grill for about 15 minutes with the lid
closed and the gas turned on "HIGH". This will "heat clean" the internal parts and dissipate odor
from the painted finish.
*Clean your grill after each use. DO NOT use abrasive or flammable cleaners,
As it will damage the parts of this product and may start a fire. Clean with warm soapy water.
If the burner does not light, turn the gas control knob off and wait 5 minutes to let the gas clear
before you try again.( please see the 5.3 Installing the gas cylinder)
5.6 Match lighting
IMPORTANT!
A match lighting hole is located on the left side of the firebox as seen below.
Downloaded from
www.Manualslib.com
manuals search engine
16
Publicité
