Cuisinart BG036-H Manuel Du Propriétaire page 16

 Always remove LP-gas cylinder from grill when transporting and when not in use.
5.3 Installing the gas cylinder
(The propane gas cylinder is not provided with the appliance.)
A gas cylinder complying with the requirements listed in section
grill can operate. Connect the LP cylinder to the grill outdoors only.
Read and follow all direction on the cylinder.
1. Turn the burner control knob to "OFF" position.
2. Remove the protective caps from the cylinder valve and coupling nut, if present.
3. Open grill lid and fold right-hand grill shelf over onto grill grate
4. Grasp the grill handle nearest to the regulator with one hand, and with the other hand push the
cylinder into the threaded regulator connector and turn clockwise until tight.
5. TIGHTEN BY HAND ONLY. Do not use tools.
REMOVAL OF THE GAS CYLINDER (please see the 5.3 Installing the gas cylinder) "picture".
1. Turn the burner control knob to "OFF" position.
2. Grasp the grill handle nearest to the regulator with one hand, and turn the cylinder
counterclockwise until it comes off.
5.4 Checking for gas leak
DANGER
Check gas system for leaks to prevent fire or explosion hazard
1. The "Leak Check" must be performed before lighting the grill and each time the cylinder is
connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use grill until all leaks have been stopped, if you are unable to stop a leak, disconnect
the propane supply, and call for gas application service or your local propane gas supplier.
Downloaded from www.Manualslib.com manuals search engine
5.2 must be obtained before the
15