AXXAIR DC221-AM1 Mode D'emploi page 25

ENGLISH
 When the facing insert comes into contact with the front face of the tube, continue
to slowly turn the rear handwheel to obtain the start of the chip, then maintain
light and constant pressure on the handwheel to maintain a fine and regular chip
 Continue this operation until the desired facing is obtained.
NOTE : A graduation = 0.1mm in advance of the insert, so a full turn of the crank = 2mm
Advice:
In order to optimize the performance of the insert and in order to obtain quality facing, it is
advisable to reduce the speed of rotation of the insert to a minimum (motor speed)
 When the facing operation is done, and before stopping the rotation of the motor,
let the insert turn on the spot in order to let the chip escape, then make a few turns
backwards with the rear handwheel to release the insert from the tube
 Then stop the rotation of the machine.
 Loosen and remove the tube.
If necessary, remove the chips remaining inside the machine.
For this operation, take all the necessary precautions to avoid
unintentional starting of the machine.
WARNING
330B Route de Portes les Valence
- 25 -
F-26800 ETOILE-SUR-RHONE
www.axxair.com