ENGLISH
5.3 User instructions:
Choose the rotation speed A (it is preferable to start machining on position 2 on the
power tool), then the rotation speed B.
Check the direction of rotation (clockwise when the operator is standing at the back
of the machine).
Risk of tipping: According to the tube's length, the machine could tip
over. If necessary, hold the tube with appropriate means.
WARNING
Using the rear handwheel, move the tool plate as far as possible
Put the tube in the machine, then position it 2 or 3mm from the cutting edge of the
insert
Tighten the tube with the tightening lever.
Start the electric motor, then slowly turn the rear handwheel to bring the cutting
edge closer to the front face of the tube.
A
B
- 24 -
330B Route de Portes les Valence
F-26800 ETOILE-SUR-RHONE
www.axxair.com