Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Visual
Reference
DC-OUT1
DC-UOUT1
DC-OUT3
DC-UOUT3
5
USE
All tool holders are mounted on the machine in the same way. Before mounting, it is
preferable to install the HSS plate on the selected tool holder.
NOTE: To facilitate tool holder mounting, apply a little high-temperature
grease, such as "ELECTROLUBE HTG - HTG50T", to the tool holder locking
screw, every time the machine is serviced.
Firstly, install the HSS plate on the tool holder. Then install and tighten the plate
screw (tightening torque = 2.55 Nm, Torx T15 screwdriver supplied).
Designation
Box
of
10
PERFORMANCE
inserts for orbital facing with DC
machines.
Double sided inserts with two
cutting edges, made of HSS-E,
TiALN treatment.
Single PERFORMANCE insert
for
orbital
facing
machines.
Box
of
10
PERFORMANCE
orbital facing with DC machines.
Double sided inserts with two
cutting edges, made of HSS,
TiALN treatment.
Single HIGH PERFORMANCE
insert for orbital facing with DC
machines.
- 20 -
330B Route de Portes les Valence
F-26800 ETOILE-SUR-RHONE
This
preferred
application requires high
rates or concerns hard
materials
DUPLEX,
SUPERDUPLEX, etc.)
with
DC
HIGH
This
inserts
for
preferred
application requires high
quality
burrs
aeronautic,
semiconductor,
microfitting, etc.)
Greasing the
locking screw
www.axxair.com
Advice
insert
is
to
be
when
your
(INCONEL,
insert
is
to
be
when
your
facings
without
(pharmaceutical,
Publicité
