AXXAIR DC221-AM1 Mode D'emploi page 22

330B Route de Portes les Valence
ENGLISH
F-26800 ETOILE-SUR-RHONE
www.axxair.com
Screw reference 1
NOTE:
It is possible to mount 3 tools.
Check that the tool holders are
mounted with locking screws facing
outwards.
This mounting balances machining
loads which will result in a longer machine
life cycle and also less frequent changing
of the HSS plate (longer servicing
intervals).
It is also possible to install the facing tool holder and a chamfering tool holder, which
enables the two operations to be performed simultaneously.
NOTE:
Caution, the setting up of the chamfering tool holder is very important and must be
very precise (see 4.1). The chamfering cut depth remains 3 mm with the tool holder
at 45°, and 6 mm with the tool holder at 30°.
English
Chamfering cut depth (tool travel)
- 22 -