AEG S41600TSW2 Notice D'utilisation page 9

Problem
The appliance is noisy.
The lamp does not work.
The compressor operates
continually.
Water flows into the refriger-
ator.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not suppor-
ted properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The appliance is not level-
led.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
ENGLISH
Solution
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock-
et. Contact a qualified elec-
trician.
Check if the appliance
stands stable.
Close and open the door.
Refer to "Replacing the
lamp".
Refer to "Operation" chap-
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
9