Publicité
Les langues disponibles
Les langues disponibles
Getting Started
Getting Started
Unpacking
Check that you received the following items:
• Audio cord (1)
• Remote commander (remote) (1)
• R6 (size AA) batteries (2)
Inserting batteries into the remote
You can control the player using the supplied remote.
Insert two R6 (size AA) batteries (supplied) by
matching the + and – on the batteries to the diagram
inside the battery compartment.
Insert the negative (–) end first, then push in and down
until the positive (+) end clicks into position.
When using the remote, point it at the remote sensor g
on the player.
When to replace batteries
With normal use, the batteries should last for about six
months. When the remote no longer operates the player,
replace all the batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you do not use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
GB
4
Hooking Up the System
Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
CONTROL A1
To an AC outlet
To ANALOG OUT (L)
To ANALOG OUT (R)
To audio input
: Signal flow
What cords will I need?
Audio cord (1) (supplied)
White
(L)
Red
(R)
DIGITAL OUT
(OPTICAL)
CD player
COMMAND MODE
Amplifier
To an AC outlet
White
(L)
Red
(R)
Publicité
