Publicité
Les langues disponibles
Les langues disponibles
Setting up the unit
You must make certain settings before you can connect the unit to your phone line.
Choose the proper settings for your telephone signaling type. You also have to set the
AREA CODE switches according to your area.
(1) Before making the settings, check that the POWER ON/OFF switch is set to
(2) Remove the battery cover.
(3) Select the telephone signaling type with the TONE/PULSE10/PULSE20
(4) Set up the AREA CODE switches according to your area.
(5) Replace the cover.
Notes
•When the Bluetooth device you are communicating with can switch the telephone
signaling type, set it to the same setting as the unit. Otherwise, the connection will not
be established properly.
•If the TONE/PULSE10/PULSE20 selector is not set to the appropriate position, you
cannot communicate with any Bluetooth devices.
•If you cannot check the dial speed of your pulse dialing phone, set the TONE/
PULSE10/PULSE20 selector to PULSE10.
10-
GB
4
OFF.
selector.
TONE: When your phone line has tone signaling.
PULSE10: When your phone line has pulse signaling.
PULSE20: Normally, this is not used. For details, see "To check the dial speed
of a pulse dialing phone" on page 11.
zTips
•How can I tell if my phone has tone signaling?
You can hear the touch pad sound from your phone when you press the number
button.
•How can I tell if my phone has pulse signaling?
You can hear clicking sounds from your phone when you press the number
button.
For details, see "The setup of the AREA CODE switches" on page 11.
The setting is completed.
3
1
Publicité
