Fujitsu AIRSTAGE ASE07L Serie Mode D'emploi page 9

TROUBLESHOOTING
The following conditions may not be breakdowns so check again.
Symptom
Doesn't operate at all:
The operation mode cannot
be changed:
Poor Cooling (or Heating)
performance:
In the following situations stop operation immediately and get in touch with authorized
service personnel.
G The problem cannot be solved even when the troubleshooting checks have been performed.
G The OPERATION indicator lamp (red) is flashing very fast.
G The wired remote controller or simple remote controller indicate EE (when connected).
G It has burning smell.
SPECIFICATIONS
MODEL
POWER SOURCE
AVAILABLE VOLTAGE RANGE
COOLING CAPACITY
HEATING CAPACITY
DIMENSIONS & WEIGHT
HEIGHT
WIDTH
DEPTH
WEIGHT
G Acoustic Noise Information : The maximum sound pressure level is less than 70 dB (A) for both indoor unit and outdoor
06G360_9377772015_en
G Has there been a power failure?
G Has a fuse blown out, or a circuit breaker been tripped?
G Is the main power switch set to the OFF position?
G Are you trying to engage in an operation different from the priority state?
G Is it in standby state?
G Are you trying to change to an operation different from the priority conditions?
G Did you adjust the room temperature settings (thermostat) correctly?
G Is the air filter dirty?
G Are the air conditioner's inlet port or outlet port blocked?
G Is there a window or door open?
G In the case of Cooling operation, is a window allowing bright sunlight to enter?
(Close the curtains.)
G In the case of Cooling operation, are there heating apparatus and computers in-
side the room, or are there too many people in the room?
G Is the fan speed set to low?
AS E07L
[kW] 2.20
[kW] 2.50
[mm]
[mm]
[mm]
[kg]
unit.
According to IEC 704-1 and ISO 3744.
8
Items to check
AS E09L AS E12L
230V~50Hz
198 to 264 V
2.80 3.60
3.20 4.10
275
790
215
9
9/8/06, 9:04 AM
See Page
—
—
—
4
4
4
—
5
—
—
—
—
—
AS E14L
4.00
4.80
En-8