Frigidaire FFFU17M1QW Utilisation Et Entretien page 4

IMPORTANT SAFETY
INSTRUCTIONS
WARNING
Other Precautions
• To defrost appliance, always unplug unit first.
• Never unplug the unit by pulling on the power
cord. Always grip the plug firmly and pull
straight out from the receptacle.
• Turning the control to OFF turns off the
compressor, but does not disconnect power to
other electrical components.
FIRST STEPS
This Use & Care Guide provides general operating
instructions for your model. Use the unit only as
instructed in this Use & Care Guide. Before starting
the unit, follow these important first steps.
Location
Choose a place that is near a grounded
electrical outlet.
For the most efficient operation, the appliance
should be located where surrounding
temperatures will not exceed 110°F (43°C).
Temperatures of 32°F (0°C) and below will
NOT affect operation. Additional compressor
heaters are not
3" (75 mm)
recommended.
Allow space
around the
unit for good
air circulation.
Leave a 3 inch
(75 mm) space
on all sides
of the unit
for adequate
circulation.
4
All manuals and user guides at all-guides.com
Leveling
The appliance must have all bottom corners
resting firmly on a solid floor. The floor must be
strong enough to support a fully loaded unit.

To level Upright Units:
After discarding crating screws, use a carpenter's
level to level the appliance from front to back.
Adjust the plastic leveling feet in front, ½ bubble
higher, so that the door closes easily when left
halfway open.
To level Chest Units:
If needed, add metal or wood shims between
feet pads and floor.
3"
(75 mm)
3" (75 mm)
Installation
FIRST STEPS
3" (75 mm)
3" (75 mm)
3" (75 mm)
NOTE
It is VERY IMPORTANT for your appliance to
be level in order to function properly. If the unit
is not leveled during installation, the door/lid may
be misaligned and not close or seal properly,
causing cooling, frost or moisture problems.
3" (75 mm)
1" (25 mm)