ARIETE RoboMix compact 1784 Mode D'emploi page 11

INSTRUCTIONS FOR USE
WARNING: Make sure that the appliance is unplugged and that the control dial (A) is set to "0" before
cleaning it or fitting or removing attachments.
- Insert the motor shaft (C) into the special seating on the power base (B) (Fig. 2).
- Fit the bowl (P) onto the power base (B) and lock it into place turning it clockwise so that the tab
in the bottom section of the handle clicks perfectly into the slit in the power base (Fig. 3).
- Fit the blade support (D) onto the motor shaft (C) inside the bowl (P) (Fig. 4).
Chopping, mixing or whisking
- To use the appliance as a chopper, fit the metal blade (E) onto the blade support (D), while for
mixing, fit the plastic blade (F) by making sure that the slots inside the base of the blade are in line
with the notches in the support and pressing the blade downwards (Fig. 5).
WARNING: The blades are sharp; handle them with care.
- To use the appliance to whisk egg whites or whip cream, fit the special attachment (H) onto the
blade support (D), as illustrated in Fig. 6.
WARNING: Before starting the appliance, make sure that the bowl (P) and the disc (H) are perfectly
clean and without any traces of butter or egg yolk.
- Cut the foods into small pieces (1.5 x 1.5 cm) and place them inside the bowl (P) or for mixing,
insert the ingredients.
WARNING: Never add foods over the maximum level marked on the bowl (P).
- Fit the lid (O) over the bowl (P) moving the mark inside the bowl (P) so that it is in line with the
symbol ( ). Block the lid (O) so it clicks into place by moving it clockwise ( ) (Fig. 7).
WARNING: Make sure that the lid is firmly locked into place before starting the appliance.
- Plug the appliance into the mains power.
- Start the appliance, selecting the rotation speed of the blade using the operating dial (A).
The appliance has two operating speeds: minimum «1» and maximum «2».
WARNING: When the appliance is used to mix or whisk, we recommend starting at speed "1" and
then passing on to speed "2". When used to chop, it is advisable to use the pulse function, turning
the dial (A) anticlockwise to the "P" setting. For optimum use, press the button in short bursts (2/3
sec.).
WARNING: Never operate the appliance for more than 30 seconds at a time. Wait at least 2 minutes
before operating it again.
- For smoother, finer chopped foods, remove the food, if necessary, from the sides of the bowl with
a spatula, pushing it towards the centre.
WARNING: Never remove foods from the sides of the bowl while the appliance is operating. Switch
off the appliance first and unplug it from the mains power.
WARNING: To prevent accidents or damage to the appliance, always keep hands and cooking
utensils well away from moving blades or discs.
WARNING: Never use your fingers to remove food from the sides of the bowl while the appliance is
operating. Always use the special spatula.
- 9 -
EN