Publicité
Les langues disponibles
Les langues disponibles
Option B: No waste disposer –
no air gap
Waste tee
Drain trap
1. Fit rubber end of drain hose
1
to waste tee and cut if needed.
NOTE: Do not cut ribbed section.
Rubber
end
2. Attach rubber end of drain hose to
2
waste tee with a large drain hose clamp
(provided). Use pliers to squeeze clamp
open and move into position. If the drain
hose was cut, use a 1
50 mm) screw-type clamp (not provided).
All manuals and user guides at all-guides.com
Large drain
hose clamp
Drain hose
/
" to 2" (38 to
1
2
Option C: Waste disposer – with air gap
Screw-type clamps
Disposer inlet
Drain trap
Helpful Tip: Remove disposer knockout plug.
1. Using a hammer and screwdriver, knock
1
plug into disposer.
2. Use needle-nose pliers to remove plug.
2
3. Connect rubber end of drain hose
3
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
Rubber
end
4. Attach drain hose to air gap with large
4
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use
a 1
/
" to 2" (38 to 50 mm) screw-type
1
2
clamp (not provided).
5. Use a rubber hose (not provided) with
5
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
Air gap
Large drain
hose clamp
Rubber hose
connector
Drain hose
23
Publicité
