PowerPeak FET8316P Mode D'emploi page 40

Step 6: Assembling the computer
Remove the four pre-assembled screws (80) from the back of the computer (1).
Connect the upper computer cable (83) with the computer (1).
Then attach the computer (1) to the bracket of the handle bar post with the four removed crews
(80).
Attach the hand pulse cable (81) in the opening at the back of the computer (1).
Step 7: Connecting the adapter
The adapter must be placed on the outside of the device. The arrow in the picture above shows the
position of the adapter connection.
MAINTENANCE AND USE

This device requires a regular check-up to prevent physical injury. This means that bolts and nuts
should be frequently checked for cracks and sharp edges etc.

Defective components must be replaced immediately. If this is not possible, the device must be
put out of order until the necessary repairs have been made.

Clean only with a damp cloth, do not use solvent cleaners.

This product is intended for use in clean, dry conditions. You should avoid storage in excessively
cold or damp places as this may lead to corrosion and other related problems.
All manuals and user guides at all-guides.com
40