Parkside PFMRA 20-Li B2 Mode D'emploi page 35

8c ] [
5 . The lock pin must click into the
corresponding slot of the tool holder .
6 . Release the locking collar back to its original
position .
7 . Twist and pull the stirrer to check if it is firmly
fitted . The stirrer must not have excessive play .
˜ Removing and disassembling
the stirrer
1 . Pull the locking collar
(direction a) .
8 ] [
2 . Pull out the stirrer
(direction c) . The stirrer must be completely
disengaged .
3 . Release the locking collar back to its original
position .
Disassembling the spiral
[ 8 ]
stirrer :
(Fig . F)
1 . Place one assembly spanner
hexagonal connector of the shaft
2 . Place the other assembly spanner on the
hexagonal connector of the spiral .
3 . Hold one spanner firmly in place while
turning the other spanner in a counter
clockwise direction to loosen the connection .
4 . Unscrew the spiral completely and remove the
spiral from the shaft .
˜ Operation
˜ Switching on/off (see Fig. H)
Switching on:
1 . Press and hold the switch lock
2 . Pull the switch trigger
switch on the product .
3 . Release the switch lock .
Continuous operation:
Keep the switch trigger pressed .
o
Switching off:
o Release the switch trigger to switch off the
product .
34 GB/IE
2 ] [
downwards
[ 2a ]
from the tool holder
8b ] [
from the
9 ] [
on the
8a ] [
.
4 ] [
.
3 ] [
downwards to
˜ Soft-start function
This product has electronically controlled
soft start function which enables the product
starting up smoothly to avoid a "kick-back" .
This function enhances safety and also
prevents the materials to be mixed from
spurting out of the mixing container .
˜ Speed pre-selection
(see Fig. G)
The product's mixing speed can be adjusted to
different viscosities .
There are 6 speed levels which can be pre-
selected .
Step 1 : 150 min –1
–1
Step 2 : 250 min
Step 3 : 350 min –1
–1
Step 4 : 450 min
Step 5 : 550 min –1
–1
Step 6 : 650 min
o Before start working, adjust the rotational
speed according to the viscosity of materials
to be mixed .
Speed control
button
[ 6 ]
[ 7 ]
NOTE
u [ 8 ]
The stirrer moves for a short while after
the product has been switched off . Do not
put aside the product until it comes to a
complete stop .
u
Always start from lowest speed setting .
Then increase the pre-selected speed until
the best mixing effect is achieved .
u
You can change the pre-selected speed
only while the battery pack
to the product .
u
Even after removing the battery from the
product: The most recently speed
pre-selection stays in place until you set a
new speed .
Rotational
speed
Increase speed
Decrease speed
10 ] [
is attached