Zeiss Secacam 7 Manuel D'utilisation page 31

3.4 Fitting the antenna
To access the mobile functions, the antenna must be fitted.
Remove the yellow protective cap and then screw the
antenna onto the top of the camera housing.
Note: To position the antenna as inconspicuously as
possible, it can be angled and rotated at the joint. The
reception and transmission of data is not affected by the
positioning.
3.5 Inserting the SIM
The ZEISS Secacam uses a SIM card for mobile radio
transmission.
Note: The camera's mobile function works exclusively with
the already inserted ZEISS Secacam SIM card. SIM cards from
other providers are not compatible.
Note: Please do not take out the SIM card or switch it for another SIM – not even for one from another
ZEISS Secacam.
The slot for the SIM card is located on the right side of the opened housing. Insert the SIM card with the
contacts facing down and the slanted corner facing to the front left until it audibly clicks into place.
4. Getting started
4.1 Switch settings
If you have equipped the ZEISS Secacam with antenna, batteries and memory card as described above, you
can basically start using the camera immediately with our factory settings.
1. Set the OFF/SETUP/ON switch to the "ON" position:
The camera is turned on and ready to use after a few seconds.
2. Set the OFF/SETUP/ON switch to the "SETUP" position:
The camera's display is now on so you can check the camera's capturing
area, preview photos, or make adjustments.
3. Set the OFF/SETUP/ON switch to the "OFF" position:
The camera is completely switched off.
1
2
3
31