Handle Assembly; Rules For Safe Operation; Debris Shield - Elem Garden Technic CBT2538 Traduction Des Instructions D'origine

10. FUEL TANK LID.
11. FUEL TANK Contains fuel and fuel filter.
12. AIR CLEANER COVER Contains replaceable felt element.
13. CHOKE the choke control is located on the top of the filter cover.
14. STARTER HSNDLE pull handle until engine starts, then return handle slowly. DO NOT let handle snap back or
damage to starter will occur.
ASSEMBLY INSTRUCTIONS

HANDLE ASSEMBLY

NOTE: The Delta Handle is attached to the shaft but has been
turned under for ease of packing.
Loosen adjustment knob and rotate handle to top of shaft
handle to top of shaft Position handle 6-1/2 to 8-1/2"from
throttle(Fig.1)
Tighten adjustment knob securely.

DEBRIS SHIELD

Shield Fits snug on shaft. Some force may be
required.
Seat shield (B) onto shaft bracket (C).
Insert washers (D) onto bolt.
Insert bolt (E) and nut (F).tighten securely.
Fig.2A Fig.2B
Fig.1
29
INSTALLING THE LOWER SHAFT
Pack the aluminum tube into the
connector inside, make the convex
ball aim at the hole on connector
Then turning the knob clockwise until it is tight

RULES FOR SAFE OPERATION

WARNING DANGER
All models trimmers and brush cutters can throw small stone, metal or small objects as well as
the material being cut. Read these "Rules for Safe Operation" with care.
Follow the instructions in your operator's manual.
Read the operator's manual carefully. Be thoroughly familiar with the controls and proper use of the unit. Know how
to stop the unit and shut off the engine. Know how to unhook a harnessed unit quickly.
Never allow anyone unit without proper instruction. Be sure the operator wears the foot, leg, eye, face and hearing or
thrown objects. Keep the area clear of bystanders, children and pets. Never allow children to operate or play with the
unit.
Do not allow anyone to enter the operating DANGER ZONE with you. The danger zone is an area 15 meters in
radius (about 16 paces) or 50 feet.
Insist that persons in the RISK ZONE beyond the danger zone wear eye protection from thrown objects. If the unit
must be used where there are unprotected people, operate at a low throttle speed to reduce the risk of thrown
objects.
Move the stop switch to "o" position when the engine idles, insure it reliable before cutting. Only may continue to
operate the unit when stop switch is in good condition.
Routines for checking that the cutting attachment stops turning when the engine idles.
30