Connect To Drain; Secure Dishwasher In Cabinet Opening - KitchenAid KUDS01DLSP6 Instructions D'installation

Connect to drain

1. To help minimize
vibration, route drain
hose to avoid contact
with motor, door springs,
water line, cabinet,
flooring or the edge of
the hole where it passes
through the cabinet.
2. Do not remove drain
loop from side of
dishwasher.
3. Place pan under end of drain hose. Pan will collect any
water in drain hose.
4. Remove plug and paper from drain connector.
NOTE: Cutting the zip tie holding the end of drain hose
in place may make maneuvering the drain hose easier
during installation.
zip tie
5. Place the smaller drain hose
clamp onto the small end of the
drain hose.
6. Push the drain hose into the connector up to the stop
on the drain hose.
connector
7. Use pliers to open clamp and slide clamp onto
connector between stops on connector as shown.
drain
loop
plug
paper
hose
clamp
stop
hose clamp
stops

Secure dishwasher in cabinet opening

WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
1. If you have not already done so, open dishwasher door
and place towel over pump assembly and spray arm of
dishwasher. This will prevent screws from falling into
pump area when securing dishwasher to countertop.
2. Check that dishwasher is still level and centered side to
side in the opening.
3. Secure dishwasher to countertop or sides of cabinet
with two, #10 x 1/2" Phillips-head screws. The
dishwasher must be secured to keep it from tipping
when door is opened. Do not drop screws into bottom
of dishwasher.
screw to countertop
4. Open door about 3 inches (7.6 cm) and check that space
between inner door and tub is equal on both sides. If
spacing is not equal, loosen bracket screws and shift
tub. Tighten bracket screws.
5. Check that top of door does not contact screws,
brackets, or countertop. If it does, dishwasher must be
lowered and re-leveled.
6. If securing to sides of cabinet, replace the plastic
buttons.
plastic
button
7. Remove towel from dishwasher.
8. Reinstall the lower dishrack.
screw to
side cabinet
OR
17