Fritz! 2400 Guide Rapide page 21

Configuring a LAN Connection
The table shows how to configure a LAN connection between the
FRITZ!Repeater and the FRITZ!Box on a computer. More configuration options
can be found in our PDF manual at en.avm.de/service.
1
Plug the FRITZ!Repeater into an electrical outlet.
Connect the FRITZ!Repeater to your computer using a LAN cable and wait until
2
the Connect LED starts flashing slowly.
http://fritz.repeater
Enter
3
FRITZ!Repeater appears.
Follow the instructions of the wizard in the user interface until configuration is
4
complete, selecting LAN Bridge as the type of connection.
Connect the FRITZ!Repeater to your FRITZ!Box using a LAN cable.
5
As soon as the Connection Quality and Connect LEDs light up permanently, the
FRITZ!Repeater is ready for operation.
On a FRITZ!Box with FRITZ!OS 7.0 or higher, enable Mesh
1
Press the Connect button on the FRITZ!Repeater. The Connect LED flashes.
Within two minutes, confirm on your FRITZ!Box that Mesh has been enabled:
• FRITZ!Box with Connect/WPS or WPS button: Press button briefly
2
• FRITZ!Box with WLAN/WPS or WLAN button: Press button for at least 6
seconds
in a web browser. The user interface of the
en.avm.de/mesh
21