Publicité
Les langues disponibles
Les langues disponibles
Before use
Note: Remove all packaging materials from the product.
The display
is covered by protective film to protect from transport damage.
5
First remove the protective film.
To operate the product, insert the included battery (9 V block). Proceed as described
below:
Inserting / changing the battery
T o insert / change the 9 V block battery
so, slide the battery cover in the direction of the arrow and flip open.
I f applicable, remove the old 9 V block battery and insert a new one. If neces-
sary, clean the contacts of the battery compartment and the 9 V block battery.
Only use a 9 V block battery type 6F22 or 6LR61.
E nsure the correct polarity when inserting the 9 V block battery. This is indicated
on the battery cover (Fig. C).
C lose the battery cover.
Your infrared thermometer is now ready for use.
Start-up
H old the handle of the product so the index finger can operate the Measure
button
and the thumb buttons
3
Switching on and off
P ress measure button
The display
5
P ress and hold the ON/OFF button
tones will sound.
W hen the product is no longer being used, the backlight of the display swill
switch off after approx. 15 seconds. After approx. 60 seconds the product
will automatically switch off; this is indicated by two brief tones.
24 GB/IE
10
or the ON/OFF button
3
will light up and a brief tone will sound.
, open the battery cover
14
to
.
12
to switch on the product.
13
to switch off the product. Two brief
13
. To do
4
Publicité
